Update 4.9f

What's hot...

Moderator: Mattk

marti
Fresh Boarder
Fresh Boarder
Posts: 13
Joined: Sat Nov 26, 2011 11:22 am
Contact:

Re: Update 4.9f

Post by marti » Tue Apr 10, 2012 8:48 pm

I have same problem in my VP2, for beginning it read all sensors, except wind, but if you wait a little bit more time, then the wind sensor start reading again.

BR,

Marti
markhiseman wrote:I just updated to 4.9f. Meteohub no longer receives a reading from the WTGR800 wind sensor on my WMR-100 station. Ther WMR-100 is receiving from the WTGR800 OK, but Meteohub says 'never' received on the sensors page. All the other WMR-100 sensors are being received OK by Meteohub.

I have tried rebooting both Meteohub and the WMR-100 with no luck. It was working fine until I updated to 4.9f.

Any ideas?

Mark.

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5025
Joined: Mon Oct 01, 2007 10:51 pm

Re: Update 4.9f

Post by admin » Wed Apr 11, 2012 1:22 am

please check windchill settings on "weather station" page. select "from station" and press "save".

marti
Fresh Boarder
Fresh Boarder
Posts: 13
Joined: Sat Nov 26, 2011 11:22 am
Contact:

Re: Update 4.9f

Post by marti » Wed Apr 11, 2012 5:26 am

OK now, thanks!

BR,

Marti

markhiseman
Senior Boarder
Senior Boarder
Posts: 61
Joined: Wed Nov 05, 2008 4:25 pm
Location: Maidstone, Kent, UK
Contact:

Re: Update 4.9f

Post by markhiseman » Wed Apr 11, 2012 8:50 pm

I tried the windchill settings tip, but still no wind reading. Tried another reset and reboot too. The other sensors are still OK, just the wind sensor is not being received, although the WMR-100 is seeing it OK.

Any more ideas???

Mark.

markhiseman
Senior Boarder
Senior Boarder
Posts: 61
Joined: Wed Nov 05, 2008 4:25 pm
Location: Maidstone, Kent, UK
Contact:

Re: Update 4.9f

Post by markhiseman » Fri Apr 13, 2012 6:50 pm

I reverted to 4.9e, and the wind sensor came back right away. Must be an issue with 4.9f.

Mark.

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5025
Joined: Mon Oct 01, 2007 10:51 pm

Re: Update 4.9f

Post by admin » Sat Apr 14, 2012 10:37 am

selecting the windchill method "from station" does not work correctly for vantage and rfxcom. problems should go away when you choose "from wind and temperature" with selecting your outdoor temp sensor.

next update will fix it anyway.

HWTest
Expert Boarder
Expert Boarder
Posts: 92
Joined: Fri Apr 09, 2010 8:25 pm

Re: Update 4.9f

Post by HWTest » Sat Apr 14, 2012 11:47 am

I would like to thank you for the windchill temperature sensor selection, it was my old wish viewtopic.php?f=16&t=8223 :-)
It works without a problem on my Sheeva + TFA Nexus.

Post Reply