I have previously developed an interface to an RFXCOM device.
With this device I can control HomeEasy or KAKU devices and receive messages from Oregon weather stations and operate Harrison curtain rails. The device supports many other protocols (X10, RFXmeter) for which I have no hardware to test...
Using luup I tried to develop a device to support this in Vera. But I have stumbled onto a problem. The RFXCOM device is connected to the network and has 2 separate ports for sending en receiving messages.
I thought I could develop a Primary device which creates 2 child devices, one for sending and one for receiving. But I found that did not work. It seems only the master device has support for network io.
How can I do this best? Should I create 2 separate devices, one for sending and one for receiving? And how can I best communicate between these two devices?
I need some direction here..
Tags: descargar tonos, message tone, tonos divertidos
This is intended for discussion and information about the rfxcom receiver module
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests