Access point mode with 3/4G USB stick

This section covers the Meteobridge PRO units exclusively

Moderator: Mattk

Post Reply
paulm
Fresh Boarder
Fresh Boarder
Posts: 13
Joined: Fri Aug 04, 2017 10:40 am

Access point mode with 3/4G USB stick

Post by paulm » Wed Aug 09, 2017 1:26 pm

I enabled the access point mode on our mbpro that is using a Huawei e303 USB stick for internet connection. Great feature! However, after disabling it again in the Network tab and using "Save and Apply and Reboot" the AP is still active after reboot and I can connect to it with my phone, even though the option is no longer checked in the Network tab. Is also see "xisaccesspoint 0" when getting the config file using the Backup option.

What's also strange is that the RX/TX traffic numbers now no longer seem to update. RX traffic even stays at 0 KB.

Operation of the mbpro (remote login, weather net upload, etc) seems to be fine otherwise, but I would really like to keep an eye on the traffic numbers (see my other post).

Post Reply