meteohub.de

I did finally get the acurite to connect to meteobridge again.

Thanks for your patience

Thanks for the link.

I was able to reset TL to DHCP.

But now acurite 1025 will send data to PC connect but will not send to meteobridge when connection swapped.

Is there some special Acurite reset needed for connect to meteobridge?

192.168.1.254 IP address for the router

Here is device info for the TL that refuses connection:

MAC Address 64:66:b3:93:cc:d4
IPv4 Address / Name 192.168.1.1 / unknown6466b393ccd4
Last Activity Mon Sep 19 05:44:11 2022
Status on
Allocation static
Connection Type Ethernet LAN-4
Mesh Client No

Success!

I pushed the large button for 10 seconds and large light is now steady

Will I have to reinstall meteobridge?

Connected with ethernet, swapped cable twice, and connected directly to the router both times.

Possible explanation:

I switched meteobridge from ethernet to wifi just before reboot; perhaps i have to leave cable disconnected but how would i enter PW?

Where ethernet plugs into router, the green ...

The narrow light on the left is steady green and the wide light on the right is flashing green.

The device that worked for years until yesterday is TL MR3020 V 1.X

I note that the MAC number no longer shows up on router device list

tp link and meteo bridge worked for years-until today after a reboot.

meteobridge no longer appears on router device list and only have one solid light and one blinking light on tp-link

I never see "Power up the device and wait until four LEDs show steady green "


ADMIN:
Help please!

after successful paypal upgrade , no key sent that is required under license tab entry slot

Meteobridge remote login had been easy using port forwarding via IPADDR:80 to my Century Link westell 7500 modem installed at my remote farm water well location,
BUT, when that modem apparently went bad and I installed the new model modem, the security features added by CenturyLink could not be ...

I already routinely upload outdoor temperature and dew-point data to WU & CWOP.

How do I upload indoor temperature and humidity data from the attic module location with 1.0 minute spacing to my PC using meteobridge over available attic Ethernet connection?

Goal is to plot indoor attic temp and ...

A SECOND REBOOT SEEMED TO SOLVE THE PROBLEM

Is there any way to delete and reinstall Weather Underground network? Yesterday WU upload quit working whereas CWOP upload continues to work. Reboot did not seem to solve the WU upload problem.

Next try is to revert to version 2.2 instead of 2.5: this downgrade solved other problems elsewhere

Using Acurite 1035 and latest version of meteobridge. Ubiquiti cam is seen by router at 192.168.0.130 but Ubiquiti initializing fails and get red X'ed out instead