meteohub.de

I am using the original 5v 1 Amp supply. But you could try doing a DIY to power the hub independent of the tl-mr3020 source. Thanks, I'll comment later on how it went.

I have problems with a tl-mr3020 version fw 1.4. When it restarts due to a power outage it does not start again, it remains downloading and when it reaches 100% it restarts. My wh1081 weather station uses a 2.0 hub when it started without it, it starts normally but it is not very sure that it starts ...

I see that WU does not show more accumulated presipitation,
I deleted all the meteobridge historical data.
Could the data be mixed because they are different models?

Hello,
I have problems meteobrige reports false rains throughout the day.
These are not listed in the console as shown in the image. My setup wh1080 + tl-mr3020 + meteobridge 3.6.
This problem did not have it with the previous wh3080.
Solution?

Excuse me, my English is a Google translation

Hello one question
meteobridge supports the LA CROSSE C86234 / WS-2814 weather station?
The connection between console and pc is by usb tranceptor

https://www.lacrossetechnology.com/c86234/

Solucion: con el telefono movil, creear "zona wifi portatil"
Ir a meteobridge---network--
Ver si aparece en lista la nueva red wifi
Si aparece y a "la que se quiere conectar no", tiene problemas el router.
En mi caso tp-link tl-wr941nd, reinstale un firmware mas viejo que el que tenia y meteobridge ...

I found the problem in the router.
Thanks for your time

the router tp link TL-WR941N working properly. I do not appear ssids

ok, I was sent URL and PASS, to info@meteo ...

the pen driver configure method, and it did not work, change of WEP and WPA connection does not work

I will prove to configure from config.meteobridge.com, you then notice

IFCONFIG:
br-lan Link encap:Ethernet HWaddr 14:CC:20:94:BE:78
inet addr:192.168.55.103 Bcast:192.168.55.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2005 errors:0 dropped:0 overruns:0 frame:0
TX packets:1298 errors:0 dropped:0 overruns:0 carrier:0 ...

WLAN is configured, but the restart and remove the LAN cable is not connected to the router

Hello from Argentina, I'm using meteobridge LAN works perfect, but when I connect by WLAM does not.
"Setup Networks" was full and still connected only by LAN. Someone may say as set by OpenWRT.
Clarification: In expert mode only appears LAN, WLAN appears disconnected.

Sorry for the bad English, I'm ...