meteohub.de

I had set the Stations tab to show #1, 2 and 3. I have now chanched that so it only shows #3 and now I'm seeing data with no '#3'.
<Edit:> And the MBPro is showing the RF-strength in the panel.

The MBPro is less than 1 m from the Davis console and still the signal is weak.

The station tab after I ...

I do not get any wind-reading, but perhaps that is an issue with the set-up of the retransmit on the console? The console reads the wind.

The signal strengths are shown below - when the MBPro is in RF-analysis-mode there are still only '--' in the display.

I have set the console til retransmit as #3. I have then set the MBPro to recieve #3 and chosen ISS. Also I have changed the direct setting to Console. The MBPro has been placed next to the Davis console.

And now I'm seeing data being transmitted. I suppose that this means that the RF receiver of ...

I'm in Europe, but the gear was bought in the US at Amazon.

Signal should be OK, but even if I move the MB right next to the ISS, I get no signal.

Frequency matches the Davis frequecy. I've even tried to change the MB to the other frequencies, with no result. Thanks for helping!

I'm 15-20 m from the ISS with a little brick and glass between us. 3-4 meters from the wind-sensor with only wood and a little plaster between us.

My brand new MB doesn't receive data from my weather station even if it next to the Davis consol that receives data nicely. I'm sure that there is some setting I have not got right, but I can't figure out which.

In the stations-tab, I have a mark in Use internal RF receiver at the top and a dot in ...