meteohub.de

It looks like I may be able to replace it myself. Is there a board layout drawing or photo available? BTW, the link you sent didn't work, but I was able to find them here with a quick search.

Worst case, I can finally upgrade to the Pro 2, which I've been trying to talk the wife into for some time ...

Attached is the System - Info tab
In case it matters, It is connected via cable to an Eero 6 port.

Meteobridge Pro. We had a power bump yesterday. Since then, no data is reaching the wx nets. Weather Underground & PWS weather both say they are receiving updates, but there is no data. Data is being received on my Vantage Vue & my Weatherlink console from the ISS. I have attached two screens ...

I have verified the rainfall issue is resolved by pouring a cup of water in the rain gauge. I am very surprised that this issue was caused by a hardware problem.

I have one final question & then I will let you be. On the Weather Networks tab under Weather Underground, there is a check box that ...

I installed the new drive yesterday (4GB). All of the parameters you had me look at became normal. The memory is again on the system/info tab, storage usage has dropped to 1%, & when I restarted the MBPro, the data storage format successfully completed. I inserted the old drive in my computer & it ...

disregard that last post. It is only some models that are discontinued.

I was just searching for the stick you recommended. It turns out that they were discontinued in 2021. Do you have any other recommendations?

Here is a photo of the memory stick. Interesting thing, when I plugged the MBPro back in, it said "formatting storage" then "formatting failed".

I just watched the video (after I took it apart). It showed pretty much what I had done. Very easy.

Does it have to be 1GB or can I go bigger?

I can disassemble it to find out. If I do have to replace it, does it have to be formatted any special way?

Here is the screen shot

I appreciate your patience with me. I've gone through your suggestions with the manual beside me. The problem is every reference has different tabs, so I was unable to look at some of the items you suggested.

I tried to set up the SMB (one of the paths I don't have) but not sure I did it right ...

It looks like storage is internal USB (1GB). It also looks like it goes back to 2021, which is when I installed this. I have a data logger in my console, so I don't use this data.

I am a novice to this system. Would you please tell me how to clear this storage data? If I back it up, will it clear ...

Totals are all zero, but there are some quantities under hourly.

It reads the same way the consoles do, receiving signal over the air. I thought the same thing about the imperial standard. I changed everything I could find referencing it. The thing is, it all worked fine until a couple of months ago. I had not changed anything when it went berserk. There is a box ...

My setup: Davis Vantage Vue station (ISS replaced a week ago for other issues). Vantage Vue console & weatherlink console. Both read properly. My meteobridge is connected via LAN due to using WiFi-6 Eeros. I send data to weather underground, PWS & CWOP. The rain data is incorrect on all of these ...