meteohub.de

You should be able to frame a specific time and the other conditions using #if# #then# #else# #fi# and send an email etc? Are you thinking of a virtual sensor with the desired conditions that triggers when all conditions are met and initiates the email? Or would it all be done on the Event tab?

I only had a quick look at the options under the Services/Events tab. Not sure exactly how to work it up.

One thing is you can create an email event at that time of day sending those parameters.

What about email "Triggered By Event"?

zakos52 wrote: ↑Fri Aug 29, 2025 7:22 pm 1.Τhe virtual sensors are visible in the image. The sensor "data0!8num" does not exist.......

You are in the TRIGGER SENSOR drop down.

Select sol0!0rate

THEN go to VIRTUAL SENSOR drop down, and choose data8!0num

Input the computation syntax.

SAVE

All I can say is that my Airlink stays connected on my MB running 6.2. I have never actually set the IP to static. But it reconnects at same address whenever it or WiFi power cycles. I had a lot of trouble before running two WiFi systems. Now I only have one network with the mesh nodes in bridge mo...

For the benefit of anyone searching, whether applicable to the OPs issue or not, I had the main mesh node wired to ISP router and everything transmitting the same SSID. Just chaos. Turned OFF the WiFi on ISP router, set nodes to bridge mode, transmitting the original SSID and PWD. Everything connect...

AA5H_AX088 wrote: ↑Sun Aug 31, 2025 3:17 pm....

- are you running a mesh system with the same SSID? .....

That caused me a world of grief. All runs smooth now with nodes in bridge mode.

Do you know how the signal strength is?

All I can say is that my Airlink stays connected on my MB running 6.2. I have never actually set the IP to static. But it reconnects at same address whenever it or WiFi power cycles. I had a lot of trouble before running two WiFi systems. Now I only have one network with the mesh nodes in bridge mod...

Latest from dev department is they intend to contact MB Admins to look at what is the hiccup.

I think I tried that but it doesn't matter. If you have wrong syntax for Virtual Sensor calculation, it will NOT show on Chart Define.

Again. Please post what you have typed in the calculation text box!!!!!

Copy and paste it here.

If you read the thread, you will see I had the same issue. It was because the syntax for the calculation on the Virtual Sensor setup page was wrong. So it never got generated. That's why I asked you what you have typed into the text block. I actually posted right after your first post. What do you s...

What is the code you input for calculation?

I'm glad I read many things that on first glance seem of no interest to me. I am quite enlightened to read the description of the proxy.

Do you need PWD to see this chart?:

https://admin.meteobridge.com/b9d9b00fb ... D2&stop=D0

I jazzed it up with UV and bumped up the resolution.