Error message

This is intended for WMR100, WMR200, WMRS200 and RMS300 specific topics

Moderator: Mattk

Post Reply
wdicken
Fresh Boarder
Fresh Boarder
Posts: 15
Joined: Fri May 20, 2011 3:21 pm

Error message

Post by wdicken » Fri May 20, 2011 3:27 pm

I am getting this error;

weathernet: No data upload to weather networks as sensor selected on weather network page for outdoor temp, outdoor humidity or outdoor dewpoint is not providing recent data.:

All of my sensors are showing data and all recent. I've tried all sorts of changes. Is there a better way to isolate this ?

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5887
Joined: Mon Oct 01, 2007 10:51 pm

Re: Error message

Post by admin » Fri May 20, 2011 7:37 pm

plaease post your settings of "weather network" page.

wdicken
Fresh Boarder
Fresh Boarder
Posts: 15
Joined: Fri May 20, 2011 3:21 pm

Re: Error message

Post by wdicken » Thu May 26, 2011 3:15 pm

Nothing selected until the weatherbug section.

WeatherBug ID p10591 Num 22187 Password *******

Selection of sensors to be used
Outdoor Temperature th0(Outdoor) Pressure thb0(Console)
Outdoor Humidity th0(Outdoor) Wind wind0(Wind)
Dew Point Rain rain0(RainGauge)
UV Index Solar
Indoor Temperature
Temp. #2 Temp. #3
Temp. #4 Temp. #5
Temp. #6 Temp. #7

Frequency of Updates
Update every 5 Min

=============================================================================
Station 0 (WH-1080): LLPS
Type # ID Name Last Signal Sensor Data
wind 0 wind0(Wind) 5 sec 2.7(1.7)m/s S
rain 0 rain0 (RainGauge) 5 sec 0.0mm/h
indoor 0 thb0 (Console) 5 sec 25.9° 53% 1012.3mb (1012.7mb) fc:-1
outdoor 0 th0 (Outdoor) 5 sec 27.7° 79%

Virtual Sensors
New ID Name Trigger Conversion Last Signal Sensor Data

wdicken
Fresh Boarder
Fresh Boarder
Posts: 15
Joined: Fri May 20, 2011 3:21 pm

Re: Error message

Post by wdicken » Thu May 26, 2011 3:47 pm

I also realized I am in the wrong forum.......

But I have one other odd error message

Mail send failed: /home/meteohub/esmtprc:3: syntax error at end of input

Thanks

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5887
Joined: Mon Oct 01, 2007 10:51 pm

Re: Error message

Post by admin » Fri May 27, 2011 7:04 pm

wdicken wrote:Dew Point Rain rain0(RainGauge)
"dew point" needs a sensor setting, should be "th0" with your setup.

wdicken
Fresh Boarder
Fresh Boarder
Posts: 15
Joined: Fri May 20, 2011 3:21 pm

Re: Error message

Post by wdicken » Tue May 31, 2011 6:34 pm

Thank you. I did finally get it. Thanks again.

Post Reply