No connection Vantage 2 pro

Davis Vantage Pro2, Pro1 (not firmware A)

Moderator: Mattk

Post Reply
Kaba-König
Fresh Boarder
Fresh Boarder
Posts: 1
Joined: Thu Feb 18, 2021 11:17 am

No connection Vantage 2 pro

Post by Kaba-König »

Hi,
I'm new here. I have installed a test version on a Raspberry 3b. My USB interface is recognized under weather station and can also be selected. If I then go to sensors, I cannot select a sensor. For example, if I go to wind0 and it does not save it. No data is displayed either.
When I try to use a PC and another program, data arrives. What can that be?
best regards
Timo

User avatar
galfert
Gold Boarder
Gold Boarder
Posts: 308
Joined: Sun Jun 24, 2018 10:31 pm
Location: Orlando, FL

Re: No connection Vantage 2 pro

Post by galfert »

Are you using an approved SLC SD card? What does the top section of the System / Information tab show for storage?
Meteobridge RPI | GW1000

Post Reply