Hi,
Can you tell me what PCI wifi card is supported by Meteohub on X86??
thanks
PCI wifi on X86
Moderator: Mattk
Re:PCI wifi on X86
Hello,
my WIFI-card is a generic one with a prism chipset:
DeviceID:0x3873 PRISMII.5 IEE802.11B Wireless LAN
VendorID:0x1260 Intersil Corporation
regards
my WIFI-card is a generic one with a prism chipset:
DeviceID:0x3873 PRISMII.5 IEE802.11B Wireless LAN
VendorID:0x1260 Intersil Corporation
regards
Re:PCI wifi on X86
Ok thanks for your answer!
I installed a PCI NERGEATR WG311 wifi card but do not appear in the Network tab settings "wireless LAN" means that this card is not supported?
Using version v4.4c DEMO!
Thanks in advance
I installed a PCI NERGEATR WG311 wifi card but do not appear in the Network tab settings "wireless LAN" means that this card is not supported?
Using version v4.4c DEMO!
Thanks in advance
Re:PCI wifi on X86
Meteohub comes prepared for a very limited set of WLAN adapters.
Meteohub's WLAN capabilities are baed on ndiswrapper. So you have to install the necessary windows drivers for your card (as always with ndiswrapper). Apart from that please have a look at /etc/rc.boot/initsensors which controls during boot if WLAN is used by Meteohub or not. When you are familar with bash scripts that should be easy reading.
Good luck!
Meteohub's WLAN capabilities are baed on ndiswrapper. So you have to install the necessary windows drivers for your card (as always with ndiswrapper). Apart from that please have a look at /etc/rc.boot/initsensors which controls during boot if WLAN is used by Meteohub or not. When you are familar with bash scripts that should be easy reading.
Good luck!