meteohub.de

blacklistedcard wrote:

admin wrote:Hm, strange. Could you please browse to "http://ip-of-your-meteohub/cgi-bin/help.cgi" to give me remote access?

Browsed and enabled.

I tried the install of 5.0s again. No Wlan0. Wan IP address is 2607

It's a raspberry Pi 3. Trust me.

The /etc/network/interface is missing any sort of reference to wlan0.

The drivers for the wifi are not loading. That's why there is no wlan0 for raspberry Pi 3. Did an rpi-update to the latest. Still no wlan0.... really I don't see the drivers under /lib/firmware.

blacklistedcard wrote:Wan IP address is 2607

This is normal. My WAN address is 2001 It is simply because it try to show your IPv6 address.

netsigi wrote:

blacklistedcard wrote:Wan IP address is 2607

This is normal. My WAN address is 2001 It is simply because it try to show your IPv6 address.

Thanks. I did not know that. Now I'm just trying to get the wireless device going.

Any luck?

Same problem here. I upgraded from a crashed iConnect and cannot get the Wifi to work. Network only shows LAN. My station is far away from any router or any other ethernet connection. Thus, the Pi/Meteohub combo is basically useless to me without Wifi. Any suggestions on how to fix this?

Cheers
Chris

The latest update installs fine, but after the reboot, the raspberry PI SDCARD file system is corrupt and will not boot. The same a previous updates for the raspberry pi.
After I reloaded from the standard image and then updated to the 5u, it went ok. After the second reboot, no wifi options.

Having setup a RPi3 with image v5.0s and updated to the latest 5.0v (Build 196).

In the log files I saw it complaints about /data/export/wd_export.csv not there so I created it and it stops complaining about that.

However Meteohub still continues to crash within 24 hours