Update 4.9f

[marti]

I have same problem in my VP2, for beginning it read all sensors, except wind, but if you wait a little bit more time, then the wind sensor start reading again.

BR,

Marti

I just updated to 4.9f. Meteohub no longer receives a reading from the WTGR800 wind sensor on my WMR-100 station. Ther WMR-100 is receiving from the WTGR800 OK, but Meteohub says 'never' received on the sensors page. All the other WMR-100 sensors are being received OK by Meteohub.

I have tried rebooting both Meteohub and the WMR-100 with no luck. It was working fine until I updated to 4.9f.

Any ideas?

Mark.

[admin]

please check windchill settings on "weather station" page. select "from station" and press "save".

[marti]

OK now, thanks!

BR,

Marti

[markhiseman]

I tried the windchill settings tip, but still no wind reading. Tried another reset and reboot too. The other sensors are still OK, just the wind sensor is not being received, although the WMR-100 is seeing it OK.

Any more ideas???

Mark.

[markhiseman]

I reverted to 4.9e, and the wind sensor came back right away. Must be an issue with 4.9f.

Mark.

[admin]

selecting the windchill method "from station" does not work correctly for vantage and rfxcom. problems should go away when you choose "from wind and temperature" with selecting your outdoor temp sensor.

next update will fix it anyway.

[HWTest]

I would like to thank you for the windchill temperature sensor selection, it was my old wish viewtopic.php?f=16&t=8223
It works without a problem on my Sheeva + TFA Nexus.