meteohub.de

I am using the new sensor age selector to alert me when my sensors have not reported any data for more than 5 minutes. Today as a test I disconnected the power from my Acurite internet bridge and observed that I did get an email when the sensor data age was more then 5 minutes (300 sec) but I also continued to get reports roughly every 10 minutes or so. I am using a "one-time" alarm that should not fire again unless all the specified sensor ages below are less then 300 seconds (indicating all receiving recent data). Why does Meteobridge send reports every 10 mins or so... is there some sort of reset when no Acurite internet bridge data is found?

Email: One-Time Alarm
Raise: ([th0temp-age] >300 || [rain0rate-age] > 300 || [thb0press-age] > 300 || [wind0wind-age] > 300 || [th0hum-age] > 300)
Clear: ([th0temp-age] <300 && [rain0rate-age] < 300 && [thb0press-age] < 300 && [wind0wind-age] < 300 && [th0hum-age] < 300)
Subj # Body: Aged PWS Sensor Alarm # Seconds since last sensor update: temp=[th0temp-age], rain=[rain0rate-age], pressure=[thb0press-age], wind=[wind0wind-age], humidity=[th0hum-age] at [MM]/[DD]/[YYYY] at [hh]:[mm].

Please click the orange info icon to understand how the clear clause is evaluated after 10 mins.