meteohub.de

I'm running the Meteohub software on an Alix (x86) embedded PC, and it's stuck in a firmware-update loop on 5.0i. The current installed version is 5.0i, when that was the latest version it would announce that a new version (5.0i again) was available and offer to install it. Now that the latest version is 5.0j it's doing the same thing, offering to install 5.0j but staying stuck at 5.0i after the reboot. Neither the system nor meteohub logs show anything out of the ordinary (apart from recording the restarts when the non-update happens).

Has anyone else encountered this, or have any ideas on what to do? I could to a manual update to 5.0j, but I'm not sure if that'll solve the update-loop problem...

Just an update to this, the move to 5.0j didn't work but 5.0k did, it's now on that version after finally breaking out of the 5.0i loop...