My Davis console (USB datalogger) does not send data anymore
Posted: Sat Jan 09, 2016 12:26 pm
When your Meteobridge stops receiving data from your Davis USB data logger for no apparent reason, there is a chance that the data sending HW in the Davis console has locked up. This does not happen very often, by a power outage or plugging data logger into a running console can make this happen. This is how to resolve the situation:
1) disconnect USB data logger from console or Envoy
2) remove batteries from console (if any)
3) disconnect console from power supply
4) wait a minute
5) reconnect USB data logger
6) insert batteries (if any) and reconnect power supply
Please keep in mind that TP-Link based Meteobridges (MR3020, MR3040, WR703N) need a USB hub in-between Davis USB data logger and Meteobridge.
1) disconnect USB data logger from console or Envoy
2) remove batteries from console (if any)
3) disconnect console from power supply
4) wait a minute
5) reconnect USB data logger
6) insert batteries (if any) and reconnect power supply
Please keep in mind that TP-Link based Meteobridges (MR3020, MR3040, WR703N) need a USB hub in-between Davis USB data logger and Meteobridge.