meteohub.de

I sometimes see an active sensor # change causing my annotated image to display dashes.
Usually I can update the command line to the latest sensor # and get things working.

I attempted to fix this again yesterday and in the procsss rebooted to the latest f/w.
Now I have Live Data sensors listed but not logged.

Anything I can do to restore logging of these sensors?

Thanks

please reboot again. new sw avail.

Did not help.

Here is the system page show the live data and logging:
https://www.dropbox.com/s/dehrxsr63zp1o ... M.png?dl=0


The startup log:
https://www.dropbox.com/s/hfv0u2haje0ys ... M.png?dl=0


The sensors detected:
https://www.dropbox.com/s/h6w0o2ntjquu8 ... M.png?dl=0


Note that the bridge is also detecting a neighbor's sensor (#14341) with low signal strength (1).

Thanks.

I examined the boot messages and noticed duplicate senor assignments to non-existent devices.
Using the unlink sensors check box on the Weather Station page restored the list to my sensors.
Working as expected now.