meteohub.de

Hello -

I have enabled the internet login on the System tab and saved the URL that it provided me. When I try to access the link from a different machine on the internet, I receive “Not Found”.

Any guidance would be most appreciated.

—Chris

Can take a few attempts to go through at times, working ok right now, just try the refresh button a few times if it stalls in going through

Thank you for your reply. I have rebooted the router several times and tried as you suggested. No luck. When I try the page, I see it go black for a second and I see "Meteobridge" in the upper left corner and then it goes back to the "not found" state. (The requested URL /cgi-bin/meteobridge was not found on this server.).

--Chris

After you put at the system tab the checkmark and copied the link: Did you do a "Save and apply" which is at the bottom of that tab?
If that does not help, a reboot of the meteobridge probably will.

Wim

Thanks, Wim. Yes, I have hit the save and apply button and the meteobridge reboots. I will do a power cycle and see what happens.

EDIT: power cycle does not help.

--Chris

Just to clarify that your remote URL looks something like the following where the xxxxxx is the specific address (32 characters) of your unit.

https://admin.meteobridge.com/xxxxxx/

That is correct.

Mine is doing the same. Set it up to give admin access to my MB and did the save and apply thing, tried to capture the "Allow login from the Internet via this URL" screen but only stays up for a very brief moment and goes the "The webpage cannot be found HTTP 404". Tried rebooting several times, re-entering the login password, save and apply and reboot and the same thing every time.

I am using the TL-WR902AC "Meteobridge 3.6 (Feb 16 2018, build 242), FW 1.1" just released today and doing the same as stated.

Andy

Andy -

I have the setup as you.

—Chris

Allow login from the Internet via this URL is still not working to allow admin to log into my meteobridge. Is it on my end or?

Any further support towards a resolution would be most appreciated.

—Chris

Looks like there has been an issue with the new WR902AC device. Problem should be fixed with just released update.

Good morning -

Thank you for taking the time to address this issue. I rebooted the WR902AC to the new release, waited 15 minutes, and tried to access remotely. The condition remains. I will do a complete power cycle and re-attempt.

Edit: Performed power cycle; no success. Still not working.

--Chris

Please reboot Meteobridge, restart your browser and try again. I just tested with WR902AC and it works.

I've done as you suggested with no luck. Is there a way for you to look at my config if I gave you the MAC ID?