This is the result after flash MR3020 v1.8

All about the standard Meteobridge devices based on mobile routers from TP-Link, D-Link, ASUS

Moderator: Mattk

Post Reply
mariomarconi
Fresh Boarder
Fresh Boarder
Posts: 7
Joined: Sun May 12, 2019 12:30 pm

This is the result after flash MR3020 v1.8

Post by mariomarconi » Sun Oct 06, 2019 8:43 pm

I flashed the MR3020 v1.8 from original firmware (TP-LINK) to meteobridge ver. 1.5 and I got the result of a figure read from serial port (Putty). Can you fix it? The lan not work. I try change bitrate on putty but not change.
Immagine.png
Immagine.png (52.12 KiB) Viewed 92 times
Thanks

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5881
Joined: Mon Oct 01, 2007 10:51 pm

Re: This is the result after flash MR3020 v1.8

Post by admin » Mon Oct 07, 2019 1:05 am

The MR3020 does not have an externally accessible serial port. If you soldered one to it on your own, you should be able to get the baudrate settings right to 115200 8N1. Apart from that the wiki explains how to access the meteobridge from your LAN. :roll:

mariomarconi
Fresh Boarder
Fresh Boarder
Posts: 7
Joined: Sun May 12, 2019 12:30 pm

Re: This is the result after flash MR3020 v1.8

Post by mariomarconi » Mon Oct 07, 2019 8:24 pm

In fact, after flashing the hardware version 1.8 I no longer got access to the MR 3020 (lan), so I opened it and connected the serial following the instructions. The result is in the previous post.

User avatar
admin
Platinum Boarder
Platinum Boarder
Posts: 5881
Joined: Mon Oct 01, 2007 10:51 pm

Re: This is the result after flash MR3020 v1.8

Post by admin » Mon Oct 07, 2019 9:59 pm

From the garbled message I can identify something like busybox, which is a clear indication that the unit has started fine. Which of the following methods did you use to find out the IP?
- magicip.meteobridge.com
- led blinking
- router log
- ip scanner

mariomarconi
Fresh Boarder
Fresh Boarder
Posts: 7
Joined: Sun May 12, 2019 12:30 pm

Re: This is the result after flash MR3020 v1.8

Post by mariomarconi » Mon Oct 14, 2019 6:33 pm

I used Advanced ip Scanner

Post Reply