meteohub.de

Hi, everyone.

I purchased a new Nano SD in November to replace Meteohub running on a RPi. The Pi itself was a replacement for Meteohub running on a Sheeva Plug ( wonderfully I might add till the PSU died).
The Pi has a few years of historical data that I would like to import into the Sd.

My first hurdle is sea level Air pressure.
In the raw file the sea level pressure shown in thb0 looks perfect ( and if viewed on a graph in the Meteohub looks fine) about 25 hpA difference from the station pressure.
When imported into the Nano however the figures are a factor of ten out... 9950 in the raw data comes out 9950 hpA not 995.0.


Am I doing something silly?

This is fixed with the current release.

Thanks Boris.
Just relieved that it wasn’t me doling something stupid.

I think there may be a similar problem with Dewpoint (th0).
Sent a PM to Boris

Fixed by Boris new release dated today