meteohub.de

Does the Meteobridge support reporting battery health from the sensor suites attached to the Vantage consoles? I see the status sensors and selectors are available in the templates, but they seem to always be set to 0, even when an ISS is reporting Low Battery to the console.

Thanks!

Curious about this too. I've recently been pushing data to AmbientWeather (my MB Nano is one of their branded ones), and AmbientWeather just reports back station battery low.

My nano is in a Weather Envoy. Pretty sure Weathercat, when I was using it for loop packets, was pulling proper battery status of the ISS, so seems like MB just needs to report this?

Thanks!

Any info on this?

I don’t see any report of iss battery status on the Meteobridge sensor information page, however there must be the capability to show it as the newest Weather 34 Dashboard does show a warning in the upper right corner when the battery is low.

Battery status (0 or 1) is reported via sensors thb0lowbat, th0lowbat etc for each of the base sensors, 1= low battery, 0 = ok

I do not have that sensor showing on my sensor mapping page and if I try to add it I am not offered a choice to add it, just a no mapping option.

bump for battery status on Davis vantage Pro2 console and sensor platform would be wonderful.