Nano Inital Connectivity Trouble
Posted: Thu May 28, 2020 9:14 pm
Hello:
I am switching my old Meteobridge setup , using a Davis VP2 and an MR-3020, over to the Meteobridge Nano. I am able to to successfully complete the first part of the process, and the "Save and Test" function reports that "WLAN and Internet Connectivity Are Fine" But when I complete the "Save and Apply and Reboot" step I am unable to access the Nano at its designated address. The Nano's LED continuously blinks quickly, suggesting no connectivity.
My IP Scanner shows the device at the designated IP address but shows it as unconnected to my network. I have powered down and repeated the process several times, only to fail at the last step each time.
You assistance is appreciated!
I am switching my old Meteobridge setup , using a Davis VP2 and an MR-3020, over to the Meteobridge Nano. I am able to to successfully complete the first part of the process, and the "Save and Test" function reports that "WLAN and Internet Connectivity Are Fine" But when I complete the "Save and Apply and Reboot" step I am unable to access the Nano at its designated address. The Nano's LED continuously blinks quickly, suggesting no connectivity.
My IP Scanner shows the device at the designated IP address but shows it as unconnected to my network. I have powered down and repeated the process several times, only to fail at the last step each time.
You assistance is appreciated!