Restore from previous backup reverts to non-activated state
Posted: Wed Nov 11, 2020 12:00 am
I did a "Backup Settings" a few days back. Today I received my new pSLC micro-SD card.
I performed the Transfer procedure at http://wiki.meteohub.de/Transfer
The system works and even has my sensors. Unfortunately, none of my graphs are present. I tried reloading the saved backup, but this causes the system to ask for reactivation and reverts to the old activation code. Apparently this is embedded in the backup?
I would really like to restore my graphs, etc. Is there a way to get this backup/restore to work without trying to change to the old activation code? I seem to be stuck in a "loop" trying to get the backup file loaded.
I appreciate any suggestions.
I decided to reconstruct the graphs and html, it's not that bad, just a little tedious....
Greg Hamel
I performed the Transfer procedure at http://wiki.meteohub.de/Transfer
The system works and even has my sensors. Unfortunately, none of my graphs are present. I tried reloading the saved backup, but this causes the system to ask for reactivation and reverts to the old activation code. Apparently this is embedded in the backup?
I would really like to restore my graphs, etc. Is there a way to get this backup/restore to work without trying to change to the old activation code? I seem to be stuck in a "loop" trying to get the backup file loaded.
I appreciate any suggestions.
I decided to reconstruct the graphs and html, it's not that bad, just a little tedious....
Greg Hamel