meteohub.de

After the death of an SD card on my Raspberry Pi running WeeWX I decided to give Meteobridge a try.
I was surprised how well it worked out.
I own my weather station since last summer. The dedicated hardware versions were to expensive for me, but the cost for this RPi version is reasonable.

Until my SLC card arrives, I wanted to set up the trial version to feed my Opensprinkler Weather Service running on another RPi.
The Official Meteobridge forum didn't allow me to register with a gmail e-mail address, so I try it here.

I added following as a HTTP event.
Temperature and Humidity gets through to the service, but rain data doesn't. Here is the article about the format.
https://github.com/OpenSprinkler/OpenSp ... rotocol.md

Here is an example from above site: Here is, how rain data should be formatted:

rainin 0.34 Accumulated rainfall in inches over the last 60 min
dailyrainin 1.45 Accumulated rainfall in inches for the current day (in local time)

An Ecowitt GW1000/Froggit DP1500 is attached with a Froggit WH3000SE is feeding the data.
It was raining today and I see rain data on Meteobridge.

Could somebody help me to get the formatting of the rain data right?

dailytainin?

andlil wrote: ↑Wed Apr 21, 2021 11:45 pmdailytainin?

Explain please?

Mattk wrote: ↑Wed Apr 21, 2021 11:59 pm

andlil wrote: ↑Wed Apr 21, 2021 11:45 pmdailytainin?

Explain please?

There is most likely a typo in the URL provided, both in the example and the URL OP is using, just guessing that it should be dailyrainin and *not* dailytainin...

With an approved memory card I was able to make some test runs with a html file, where I was able to see the results.

I changed the code to following, where rain data is also a floating point number.
It was accepted by the service, but I also changed the "dailytainin" to "dainlyrainin".
I might have to wait another day until the service gathers enough data to see, if the changes were successful.
I will submit new results.

It was that typo that caused my problem.
The weather service for the sprinkler is now up and running.

Thank you!

bekesizl wrote: ↑Fri Apr 23, 2021 8:04 pm It was that typo that caused my problem.

Great that it worked, I fixed the typo in the source on Github as well.

//A