meteohub.de

I had to replace my Reolink RLC-410 camera with a RLC-510WA. The new camera is up and running but I haven't been able to get it working on my Meteobridge (Weatherbridge).

I entered a link recommended by Reolink Support into the Cam setup box on Meteobridge. The link is virtually the same as I was successfully using with the previous camera. When I enter the new link in my browser bar of my computer, it does produce the latest image from the new camera.

However, with the new camera link that I am using in the Meteobridge Cam setup, I get a message that says "no such image exists". In the Weather Networks section, when I click on the camera icons, it shows the last image produced by the OLD camera just before it failed, including the overlay.
I should add that when I enter the new link, all the check marks show as green.

Hoping someone can help me get the new camera setup working on Meteobridge. Thanks, Bill

What camera URL did you use in Meteobridge?

I entered this URL in the Cam set-up:
http://192.168.1.173/cgi-bin/api.cgi?cm ... d=xxxxxxxx

It shows a green checkmark but clicking on the webcam icon displays a broken image icon.

when you enter this URL in your browser, what does it reply when you try to inspect the source code?
Can your browser store the image as a file on your computer?

Typical failure is, that the URL does not return a JPEG but
- a movie stream
- a HTML page where a picture is included

Regards,
Boris

Thanks. I think the issue is on my end and Reolink is working with me, so hope to know more soon.