meteohub.de

Hi

Have just done upgrade to the latest 4.1f. I have assigned weather station RFxcom/usb. I am now trying to install the sensors, for some reason that I have not yet fathomed out,:ohmy: it is not seeing the wind sensor. The Wmr698 is still reading all sensors OK.

The other small point is that when I go to save the data in the "select sensor window" it comes back with the answer that "this sensors has the same name more than once"

The other small point is that when I go to save the data in the "select sensor window" it comes back with the answer that "this sensors has the same name more than once"

I can't speak for the first problem, but I had this same problem when I upgraded from version 3 to 4. On the sensors page, you first need to clear all the sensor IDs/names at the bottom of the page in the "Additional IDs to be evaluated" section (these aren't associated with any station, but still have names and sensor IDs -- presumably as part of the new feature to enable logging additional external data.)

Once you clear those, then you can re-assign them to the actual weather station and give them the same names you were previously using.

sevenless wrote:

I can't speak for the first problem, but I had this same problem when I upgraded from version 3 to 4. On the sensors page, you first need to clear all the sensor IDs/names at the bottom of the page in the "Additional IDs to be evaluated" section (these aren't associated with any station, but still have names and sensor IDs -- presumably as part of the new feature to enable logging additional external data.)

Once you clear those, then you can re-assign them to the actual weather station and give them the same names you were previously using.[/quote]

Hi

Thanks for the info, I will try once meteohub has finished it's re-compute data.

sevenless

Thanks for that, all is well:cheer: . I will have to re-assign the newly named sensors to the graphs or at least a few of them.