meteohub.de

I am using a RFXcom receiver, Oregon Scientific equipment and a RFX meter.
The readings of the RFXmeter are the raw value like 1648123.00, this represents the value of 1648.12 KWh
In my graphs I like to use the real KWh value and not the raw value.
Anybody knows how to set a divider in the graph scale? Something like the raw value divide by 1000?

Thanks in advance, Henk

HeinrichH wrote:I like to use the real KWh value and not the raw value.
Anybody knows how to set a divider in the graph scale? Something like the raw value divide by 1000?

Have you considered using Sensors => Calibration to apply a factor there, so that the figure is seen as a KWh value throughout?

David

David, good tip! Thanks