Page 1 of 1
Replace SD-Card with new one - Reactivation needed?
Posted: Mon Dec 05, 2011 12:30 pm
by MeteoSheeva
Hello there,
I am planning to replace my probably non-SLC-Card (Transcend 8GB Extreme-Speed SDHC TS8GBSDHC10) with an SLC-card (integral Endurance 8GB SDHC INSDH8G10-ENDU).
So my plan is to mirror the content of the old card to the new card by using GParted.
Is there a kind of reactivation needed after that? If so how do I do that?
Kind regards
Re: Replace SD-Card with new one - Reactivation needed?
Posted: Mon Dec 05, 2011 3:01 pm
by wfpost
not sure if you need to renew activation with only a new disk installed,
but you can always create a new key with that online tool >>>>
http://wiki.meteohub.de/Transfer
Re: Replace SD-Card with new one - Reactivation needed?
Posted: Mon Dec 05, 2011 11:28 pm
by admin
SD card change does also change system ID. Therefore you need to transfer activation code with the link given above. Make sure to pick the right scenario.
Re: Replace SD-Card with new one - Reactivation needed?
Posted: Tue Dec 06, 2011 12:19 am
by MeteoSheeva
Thank you for your replies.
I will try it then and give some feedback
Re: Replace SD-Card with new one - Reactivation needed?
Posted: Thu Dec 08, 2011 11:30 pm
by MeteoSheeva
I just mirrored the content from the old card to the new card and reactivated my Meteohub-installation.
It seems to be working fine.
Old:
Code: Select all
Medium: 00000 11/2010 0x7555f16e
Swap: 0MB von 131MB belegt (0%)
System: 653MB von 838MB belegt (78%)
Daten: 318MB von 6555MB belegt (4%)
New:
Code: Select all
Medium: SD08G 03/2010 0xc70bed17
Swap: 0MB von 131MB belegt (0%)
System: 653MB von 839MB belegt (77%)
Daten: 317MB von 6781MB belegt (4%)
@Boris
With one of the last updates you added the information about the SD-Card (Medium:).
Can you perhaps explain what is the meaning of these three values?