Page 1 of 1

Setup

Posted: Thu Jun 19, 2014 11:04 pm
by xcom
I just setup a new meteohub-rpi. No matter what I did the system could not detect my Vantage Vue.
Is there a special setting for the Vue?
Do I need a usb hub like the meteobridge?
Is there a setup instruction for this?


Also I keep getting the following error:

error connect socket 127.0.0.1:5555 :Connection refused
Warning: Data logging has been halted

It also complaints about expired license even though I am on demo
Any ideas?

Thanks!

Re: Setup

Posted: Fri Jun 20, 2014 12:29 am
by xcom
Here is what I get on the logs:

logger (19.06.2014 17:21:52): connect station 0 (Vantage via USB serial).
logger (19.06.2014 17:21:53): station 0 (Vantage), wakeup sent.
logger (19.06.2014 17:21:53): station 0 (Vantage), internal logger activated.
logger (19.06.2014 17:21:53): station 0 (Vantage), syncing.
logger (19.06.2014 17:22:03): station 0 (Vantage), gettime request sent.
logger (19.06.2014 17:22:03): station 0 (Vantage), no Vantage time offset.
logger (19.06.2014 17:22:03): station 0 (Vantage), eeprom request sent.
logger (19.06.2014 17:22:03): station 0 (Vantage), rain collector size 0.01 inch per tick.
logger (19.06.2014 17:22:03): station 0 (Vantage), transmitter 1 active as station type (#0) "ISS".
logger (19.06.2014 17:22:03): station 0 (Vantage), firmware version request sent.
logger (19.06.2014 17:22:03): station 0 (Vantage), firmware version 3.00
logger (19.06.2014 17:22:03): station 0 (Vantage), no reading of Vantage's internal logger as time stamps of logged data appear being invalid.
logger (19.06.2014 17:22:53): parent process received termination signal (15).
logger (19.06.2014 17:22:53): child process received termination signal (15).
logger (19.06.2014 17:22:53): disconnect station 0 (Vantage): wrap-up
logger (19.06.2014 17:22:54): data logger stopped.
logger (19.06.2014 17:22:55): Demo license timed out. Please contact "info@meteohub.de" to get a valid license.
logger (19.06.2014 17:23:29): Demo license timed out. Please contact "info@meteohub.de" to get a valid license.

Re: Setup

Posted: Fri Jun 20, 2014 8:14 am
by YJB
Hi,

From what I can see the time on either Meteohub or your Davis kit is out of sync. The log shows that you are communicating:

Code: Select all

ogger (19.06.2014 17:22:03): station 0 (Vantage), no reading of Vantage's internal logger as time stamps of logged data appear being invalid.
You can extend the demo license by going to the maintenance page and do an update. I believe the current version last until July.

Ysbrand

Re: Setup

Posted: Fri Jun 20, 2014 7:28 pm
by xcom
Thanks for your reply!
I bought a license :)