meteohub.de

I got the same result, Wlan is not working for me

I have now installed NOOBS operating system on my raspberry and the wifi work on that system i will try to install the meteohub again from start and see if it work now.

Yes i had reboot it whith the network cable out several times and with 2 different routers and i got the same result.

I have tried the Edimax on my windows conputer with success

I have a problem with wifi on the Raspberry, i have a Edimax 7811UN which is recognized by meteohub and i can see the ip adress for the meteohub in my router but i cannot ping it or get into the meteohub interface?

When i put back the network cable in Raspberry i reach the interface on the ip ...

http://hem.bredband.net/caroline_anders ... index.html

Regards

Johan

I have ordered a new weather station since my old ELV WS-500 says that the temperature outside is 42,2 degress C and it is -1 degress C, i ordered the Oregon WMRS 200 and hope that this station is a bit better than the ELV was.

I am also looking at this station as it seems to be good value for money

Regards

Johan

I got it up and running, it was as you said an error on the PICO 4gb USB, now everything seems to be ok, i only have some setup to do.

Thank you for your help!

The image i used to try to get the iconnect back to orginal software was iomegas orginal imager which there was an link to on the How to get meteohub on iconnect page, that could be the differense because in that description you should apply mains on and then within 10 seconds you should press and ...

Yes, i have downloaded it from the site, as it says that i could try it for x month and try it out before i buy it, i use the tool from smartbedded to install it on the USB memory and i push the reset button before i connect the mains but it would not work, and i could not install the orginal ...

Hi,

I purchased an Iconnect and tried to install the meteohub software on a Super Talent PICO 4gb USB, after that the the Blue LED flashes forever, i have tried to install the iomega imager software but it does not work, same thing happens the Blue LED just flash

Any idea anybody?

Hi,

I purchased an Iconnect and tried to install the meteohub software on a Super Talent PICO 4gb USB, after that the the Blue LED flashes forever, i have tried to install the iomega imager software but it does not work, same thing happens the Blue LED just flash

Any idea anybody?