TE923 cannot receive additional sensor data

[xiocc]

First of all, great software! I am currently in trial mode and planning to buy it.

I have a Meade TE923W-M with additional temp/humidity sensors, connected to a D-Link TL-MR3020, running on MeteoBridge 1.1 (1446). I have configured HTTP upload and I am getting the values for the built-in (indoor and outdoor) sensors. However, even though I can see the data from my additional temp/humidity sensors on the station itself (selecting different channels), I can't seem to figure out how to upload them through HTTP. Any ideas? Thanks a lot!

My HTTP upload URL is:
http://192.168.11.2/meteobridge/?outdoortemp=[th0temp-act:]&indoortemp=[thb0temp-act:]&th1temp=[th1temp-act:]&th2temp=[th2temp-act:]&th3temp=[th3temp-act:]

On the receiving end (simple PHP web page), I get:
20130401-210619:outdoortemp=17.3
20130401-210619:indoortemp=22.2
20130401-210619:th1temp=
20130401-210619:th2temp=
20130401-210619:th3temp=

[admin]

as mentioned in the wiki, meteobridge does not support additional sensors.
there has been a request for additional vantage sensors and i implemeted that.
when you would like to have that, i could also add additional sensor support for TE923.
how many additional temp/hum sensors can be attached to this type of station?

[xiocc]

Sorry I must have missed that in the Wiki. Yes, it would be great if you could add support for additional sensors for it. It can have up to 4 additional sensors. See also at http://www.meade.com/product_pages/weat ... te923w.php. Let me know if you need more info or help in testing. Thanks!

[admin]

ok, support for 4 additional temp/hum and/or temp-only sensors will be part of the next update to be expected sunday evening.

[xiocc]

Fantastic! Thanks!

[xiocc]

I just upgraded to the latest release (1510) by doing a reboot. The additional sensor data is available now. Great job, thanks a lot!