show weather network/triggerd status values in template

[MarKel]

hi,

i was looking at the live data tab in meteobridge and noticed the part:

"weather network status" which shows the weather network and push service status/results

would it be possible to extract/show these values inside a template (like a variable), so i could use them like:

current upload status to <weather network>
last triggered alarm by email/twitter on <date time, perhaps even value>

for the alarms it would be useful i case of not receiving an alert (by email/twitter) but it has been sent by meteobridge
for weather networks it would be usefull to know if upload is succesful or not.
i know i can see the results by going to the meteobridge ip-address itself but it would be more usefull (i think) to have it shown
on a template/report page online.

regards,

Marcel

[wvdkuil]

I would like that also.

One meteobridge is on another location so using the web interface is clumsy. SSH and port settings are blocked by the cable provider. So I can show the time the data is received at the webserver but more information about upload statusses, alarms and so on can be very handy.

Wim