RPI 3 support now available

[admin]

You now find an image for RPI model 3 in the images download section:
http://wiki.meteohub.de/Images

It is not heavily tested yet, so please feel free to report problems in this thread.

[dxwilli]

this works fine now, thanks for your support, Boris

[dbugmann]

I upgraded from an RPi2 (HW failed) to RPi3. Following issues were discovered:
- my old "Activation Code" from the RPi2 does not work anymore. I tried a "Restore Settings" as well as cut and paste the key from an ASCII-File. System Info says "Limited Demo Version, 425 days left"
20161103 update: found http://wiki.meteohub.de/Transfer and installed new key. works fine now

- Software Update (Auto) shows "Ready to install 5.0s" although 5.0s is already installed.

Regards,
Dominik

[ipe]

It works fine.

Thank you.

[admin]

I upgraded from an RPi2 (HW failed) to RPi3. Following issues were discovered:
- my old "Activation Code" from the RPi2 does not work anymore. I tried a "Restore Settings" as well as cut and paste the key from an ASCII-File. System Info says "Limited Demo Version, 425 days left"
20161103 update: found http://wiki.meteohub.de/Transfer and installed new key. works fine now

- Software Update (Auto) shows "Ready to install 5.0s" although 5.0s is already installed.

Regards,
Dominik

New hardware or new SD card will result into a new System ID which needs a new activation code.
Activation codes can be migrated from one System ID to the other (but not in cycles)
via this link: http://wiki.meteohub.de/Transfer

[cbhiii]

I have a RPI 2 (running Meteohub 5.0p) and would like to move it to my RPI 3.

Does anyone see any issue with simply upgrading the RPI 2 software to version 5.0s and then moving the SD card over to the new RPI 3 hardware and booting it?

(I realize that I'll need to transfer my license and all that too.)

[blacklistedcard]

The new Raspberry Pi 3 is working great. I noticed that my wan IP address is incorrect.

I would also love to see the wireless LAN be an option to setup on the raspberry pi 3.

[admin]

Please do an update to 5.0s (even if you are on 5.0s) as I added some hot fixes during
the last week that allows to use WLAN and WAN IP also is displayed fine now.

[blacklistedcard]

Ok. Loading it now. I'll test it out.

[blacklistedcard]

Installed update again. Did not resolve the problem.

[admin]

Hm, strange. Could you please browse to "http://ip-of-your-meteohub/cgi-bin/help.cgi" to give me remote access?

[admin]

I received a link to login, but the system page says it is a RPI model B.
WAN IP looks fine to me and Model B does not have WLAN on board.

I doubt you have a RPI3... Or you did not do a fresh install with the RPI3
supporting image.

[cbhiii]

Sorry - that is probably my fault. I clicked the 'help' link on last message from my phone to see what the code was ran. I'm still running a RPI 2 Model B (my system ID ends in ...xp5). The other user is probably not. Apologies.

[admin]

Thanks, that explains a lot
So I wait for the next remote access granted...

[blacklistedcard]

Hm, strange. Could you please browse to "http://ip-of-your-meteohub/cgi-bin/help.cgi" to give me remote access?

Browsed and enabled.