RPI 3 support now available

[blacklistedcard]

Hm, strange. Could you please browse to "http://ip-of-your-meteohub/cgi-bin/help.cgi" to give me remote access?

Browsed and enabled.

I tried the install of 5.0s again. No Wlan0. Wan IP address is 2607

It's a raspberry Pi 3. Trust me.

The /etc/network/interface is missing any sort of reference to wlan0.

[blacklistedcard]

The drivers for the wifi are not loading. That's why there is no wlan0 for raspberry Pi 3. Did an rpi-update to the latest. Still no wlan0.... really I don't see the drivers under /lib/firmware.

[netsigi]

Wan IP address is 2607

This is normal. My WAN address is 2001 It is simply because it try to show your IPv6 address.

[blacklistedcard]

Wan IP address is 2607

This is normal. My WAN address is 2001 It is simply because it try to show your IPv6 address.

Thanks. I did not know that. Now I'm just trying to get the wireless device going.

[MrReview]

Any luck?

Same problem here. I upgraded from a crashed iConnect and cannot get the Wifi to work. Network only shows LAN. My station is far away from any router or any other ethernet connection. Thus, the Pi/Meteohub combo is basically useless to me without Wifi. Any suggestions on how to fix this?

Cheers
Chris

[blacklistedcard]

The latest update installs fine, but after the reboot, the raspberry PI SDCARD file system is corrupt and will not boot. The same a previous updates for the raspberry pi.
After I reloaded from the standard image and then updated to the 5u, it went ok. After the second reboot, no wifi options.

[ON1DQD]

Having setup a RPi3 with image v5.0s and updated to the latest 5.0v (Build 196).

In the log files I saw it complaints about /data/export/wd_export.csv not there so I created it and it stops complaining about that.

However Meteohub still continues to crash within 24 hours