Problem /Help wanted - Meteobridge not starting

[RobertD]

I have a TPLink 2030 Ver.1.9 I have had Meteobridge running for around 9 months or so, suddenly the data stopped.
I have tried various fixes, including reflashing the unit. Currently at startup, the LED comes on solid for 8 sec, then flashes for 60 sec, then fast flash for 45 sec. This cycle repeats. At seemingly random intervals, I am able to log in using the ip address or http://192.168.1.50/cgi-bin/luci
But I have been unable to find the problem.
Any assistance would be very welcome.
Running Win10, WeatherFlow Tempest, and connecting to the TP-3020 (currently) via ethernet.
Was using WiFi, but despite config looking good, can not currently connect to it.

[RobertD]

Very disappointing to have not have a single reply despite the request for assistance being posted over a month ago.

[admin]

Did you try reset to factory defaults as explained in the wiki www.meteobridge.com? I tis the "five blinks" reset.

[RobertD]

Yes - I tried resetting & even going as far as reflashing the program onto the device.

Unfortunately the lack of response meant I was no longer recording data...no point in having a weather station if the data isn't recorded..!!

I have gone over to Weather Display - the forum there is very prompt & helpful.
Just a shame to have spent the $$ on a licence & then have to discard it.

[admin]

Sorry, but what can I do if your system stops working after a couple of months? When you don't get it working again with the information in the wiki my guess is that the HW failed.