Weatherflow tempest sensors..

[Ben]

As a result of some testing equipment I got from WeatherFlow, I now have 2 Tempest units.
Both seem to be reaching the MeteoBridge Pro Red I have here.
For one unit I need to ignore/switch off the Wind/Anemo sensor/data (it's not suitable due to its placement)
For the second unit I need to ignore/switch off the Pressure sensor/data (it's broken).

Then the result of the two yields:
- 2 Lightning sensors,
- 2 T sensors,
- 2 RH sensors,
- 2 UV/Watt sensors
- 1 functional pressure sensor
- 1 functional wind sensor

How do I switch off the one pressure sensor and the one wind sensor that don't need to be used? Do I just change their mapping to nothing? How do I find out which sensor is which, because the mapping does not match the Live Raw Sensor Data?
Under the History tab I could get the source sensors by holding the mouse over it. So I then mapped them to "no mapping" but they keep getting mapped back. What's up with that?

[Ben]

OK, this is somewhat disappointing. It took me 10 minutes to selectively use only the sensors I prefer with the WeeWX udp driver for weatherflow devices.
Seems I have no real use for the meteobridge anymore.

[admin]

You can define on "Mapping" tab which sensors to use as "primary" for feeding weather networks etc.
Meteobridge is very different from weeWX. So you will need a bit to adapt... as it would be the other way round.