Meteobridge FORMAT failed

[joder]

As the title indicates it seems that my red meteobridge is starting to slowly kick the bucket.

I get a format failed on boot and then the unit doesn't seem to properly read my weatherstation sensors. Is there a way to get a new internal USB stick? Also, the dispaly has some decent burn in. Not sure if these are replaceable as well?

The good news is that I got a PRO2 to replace it and the signal difference is nearly 10db!

[Mattk]

How old is the unit? If the internal USB stick is not SLC industrial then USB failure will happen in due course. Internal USB replacement needs to be a certain physical size. ATP Nano Dura works/fits well, typical available from Mouser or Digi-Key etc https://www.youtube.com/watch?v=Wn0_tM_jjZI

I have heard of the display being replaced but recall it is a bit close quarters technical thing. One reason I run the Display Control [always off]

[admin]

Please post result of "http://ip-of-your-meteobridge/cgi-bin/system.cgi?lsusb" so that I can judge if it with the USB stick or the USB hib chip (which more often is the cause of problems).

[joder]

Please post result of "http://ip-of-your-meteobridge/cgi-bin/system.cgi?lsusb" so that I can judge if it with the USB stick or the USB hib chip (which more often is the cause of problems).

command: lsusb
-------------
lsusb: cannot open "/usr/share/usb.ids", No such file or directory
Bus 001 Device 001: ID 1d6b:0002
-------------

[admin]

Thanks, that proves the internal USB hub chip needs replacement. I can do the repair (including change of OLED) for 50 Euro. When you are in EU shipping back is on my cost. If you are outside EU we should pm: info@smartgedded.com

[plex]

Thanks, that proves the internal USB hub chip needs replacement. I can do the repair (including change of OLED) for 50 Euro. When you are in EU shipping back is on my cost. If you are outside EU we should pm: info@smartgedded.com

Can you repair mine as well?