Calibrate Sensors

[doublecheese]

Hi

I have a question about sensor calibaration on Barometric Pressure.

My current station height is 96m
My BTHR918N - reading is 1006mb

Without any sensor calibration Meteoplug is calculating the pressure as 1017.3mb

When I goto Sensors page I see that : 1006mb (1017.3mb) fc:1

The real local Sea Pressure is 1011mb , now will I do the Sensor Calibration ? According to what I understand , I must goto sensor calibration page and calibrate the FACTOR (a) reading by 0.9940 to reach the desired 1011mb isn't it ? I left the offset (b) blank...

Once I do this I still get the 1017.3mb, where am I doing wrong ?

Thanks

[admin]

I would do by an offset of -6 mbar , not a factor, but that does not change your idea in principle.

could you please post a screen dump of your calibration page?

[doublecheese]

OK , I am taking some screen shots and I will send them to you..

[doublecheese]

Ok , Here are the screen Shots :

I'm also sending you my personal IP Address and User and Pass by seperate e-mail , please get into my Meteohub and try to see if you can understand why I can't calibrate my sensor ...

BTW, Since I could not get the FACTOR (A) to calculate, I tried with (-) minus Offsee but it didn't work either.

Please see the pics

[admin]

thanks, as I receive quite some mail regarding calibration not working with 4.6k, I will deep dive into this shortly.
good news is, that meteohub will repair calibration effects when installing next update which fixes this, as calibration does not change raw data.

[doublecheese]

Boris Hi

When should I expect a solution from you for the error on hPa Pressure calibration ?