Errors when daisy chaining Meteohubs port 5550
Posted: Wed Jun 03, 2015 3:08 pm
Meteohub_1 => attached to Davis VP2
Meteohub_2 => uses Meteohub-1 ip:5550
All day Meteohub-1 receives normal sensors info, sometimes Meteohub-2 sensors page shows out-of-range values which make nonsense of the min-max values.
Image top part is second Metehub, bottom part first Meteohub (click on the image to enlarge)
Left is second meteohub which used the out of range values to mess up moisture and temp min/max values.
These error values occur during Meteohub to Meteohub communication using an IP network.
So how are these errors introduced?
If the first Meteohub accepted the values, they should arrive un-modified at the next Meteohub.
If the first one rejects the values, it should not sent those values on port 5550.
Wim
Meteohub_2 => uses Meteohub-1 ip:5550
All day Meteohub-1 receives normal sensors info, sometimes Meteohub-2 sensors page shows out-of-range values which make nonsense of the min-max values.
Image top part is second Metehub, bottom part first Meteohub (click on the image to enlarge)
- soil sensors2.jpg (181.96 KiB) Viewed 1755 times
- soil sensors1.jpg (238.82 KiB) Viewed 1755 times
So how are these errors introduced?
If the first Meteohub accepted the values, they should arrive un-modified at the next Meteohub.
If the first one rejects the values, it should not sent those values on port 5550.
Wim