meteohub.de

i have the davis vantage pro 2 weatherstation. the console (6312eu) has the firmware 3.15 installed.
connected is the original weatherlink usb datalogger (6510USB). the console is already set to 19200.

i use the newest version of meteohub (5.0n) on the raspberry pi. raspberry is connected over an usb hub to the davis vantage pro2 console.
on meteohub i see the two attached devices: /dev/ttyUSB0 /dev/ttyMH113

you can see my configuration below. but i don't see any sensors?
what i make wrong? any ideas?

i already reset the console and reinstalled meteohub. but always the same

Console needs a complete power cycle (USB off, batteries off, power supply off).

solved. changed the console.