meteohub.de

Ok, I have a Davis VP2+ and Meteobridge Pro

On the main station, I have the temp/humidity and rain sensor. Station #1

On another wireless transmitter, I have the wind, UV and solar sensors. Station #2 setup up via dip switches.

I set both up as ISS -- Was that correct?

Under Davis config the Wind can be a separate ISS but the UV & Solar is part of the main ISS which appears to be the same requirements for MB Pro

But I removed the solar sensors and placed them with the wind sensors...

The solar & UV sensors have to be connected to the ISS and there can only be 1 ISS (as such) configured. If you want to connect UV/Solar with the wind sensor then you would have to make the Anemometer transmitter the ISS and config your station #1 as a Temp/Humidity transmitter but then you have no rain (on station #1) unless of course you were to connect your rain collector to your station #2 (now being the main ISS)

Mattk wrote:The solar & UV sensors have to be connected to the ISS and there can only be 1 ISS (as such) configured. If you want to connect UV/Solar with the wind sensor then you would have to make the Anemometer transmitter the ISS and config your station #1 as a Temp/Humidity transmitter but then you have no rain (on station #1) unless of course you were to connect your rain collector to your station #2 (now being the main ISS)

Mb Pro -- I set up both as ISS

Screen dumps would really help. To me it is not clear what has been defined on "station" tab.

Screenshot

Settings look ok to me.
What data is shown on live data tab? Everything showing up there as expected?