Bad wind0(0) sensor data, "chill x10"
Posted: Thu Oct 03, 2019 9:33 pm
My TL-MR3020 is giving me an error about wind sensor data right after boot.
logger (03.10.2019 12:08:06): sensors are now providing data.
logger (03.10.2019 12:08:06): services started.
logger (03.10.2019 12:08:09): Bad wind0(0) sensor data, "chill x10" (-999) out of range [-700:1500]
logger (03.10.2019 12:08:51): message above repeats 6 times.
I don't get the error again at all until I reboot. Is this anything to worry about?
My anemometer is an Ecowitt WS68 and my station is the GW1000.
I have a suspicion that since my temperature sensor is separate and doesn't send data at intervals as fast as the anemometer, there is a brief moment at boot up where my TL-MR3020 has wind speed but no temperature information, so it can't calculate wind chill properly. But that's just a wild guess.
logger (03.10.2019 12:08:06): sensors are now providing data.
logger (03.10.2019 12:08:06): services started.
logger (03.10.2019 12:08:09): Bad wind0(0) sensor data, "chill x10" (-999) out of range [-700:1500]
logger (03.10.2019 12:08:51): message above repeats 6 times.
I don't get the error again at all until I reboot. Is this anything to worry about?
My anemometer is an Ecowitt WS68 and my station is the GW1000.
I have a suspicion that since my temperature sensor is separate and doesn't send data at intervals as fast as the anemometer, there is a brief moment at boot up where my TL-MR3020 has wind speed but no temperature information, so it can't calculate wind chill properly. But that's just a wild guess.