Newbie - only dataNNnum channels visible - **solved**
Posted: Thu Dec 31, 2020 5:31 am
Hi all,
Love the Forum activity. Afraid that I have to dumb all the intelligent discussions down with this newbie problem. Hoping someone can provide some guidance. Will be powering down the whole unit (remove power cable and batteries) tonight to see if this does anything.
The Davis Vantage Pro 2 system (6152AU) is functioning well with all data being displayed on the console. Nano SD is connected to the Wifi with a fixed IP address.
Have connected and configured my MB Nano SD into the Vantage Pro console per the instructions. Have now done this twice.
I am currently only able to see the dataNNnum channels.
Data is being streamed to WU without issue, but it is limited to this data only.
Thanks in advance for your thoughts.
Best regards,
Jason
Love the Forum activity. Afraid that I have to dumb all the intelligent discussions down with this newbie problem. Hoping someone can provide some guidance. Will be powering down the whole unit (remove power cable and batteries) tonight to see if this does anything.
The Davis Vantage Pro 2 system (6152AU) is functioning well with all data being displayed on the console. Nano SD is connected to the Wifi with a fixed IP address.
Have connected and configured my MB Nano SD into the Vantage Pro console per the instructions. Have now done this twice.
- Setup in VPro2
- JayMacofOz - MB Nano SD in Pro 2 Console - Station - Primary Station.png (143.07 KiB) Viewed 828 times
- Sensor mapping
- JayMacofOz - MB Nano SD in Pro 2 Console - Station - Mapping.png (62.4 KiB) Viewed 828 times
- JayMacofOz - MB Nano SD in Pro 2 Console - Live Data - Upload Status.png (45.35 KiB) Viewed 828 times
- JayMacofOz - MB Nano SD in Pro 2 Console - Live Data - Raw Sensor Data.png (70.2 KiB) Viewed 828 times
Best regards,
Jason