Page 1 of 1
Data not reaching Wx nets
Posted: Thu May 01, 2025 4:09 pm
by Laxet
Meteobridge Pro. We had a power bump yesterday. Since then, no data is reaching the wx nets. Weather Underground & PWS weather both say they are receiving updates, but there is no data. Data is being received on my Vantage Vue & my Weatherlink console from the ISS. I have attached two screens showing errors.
Re: Data not reaching Wx nets
Posted: Fri May 02, 2025 3:07 pm
by admin
Can you please show "System - Info" tab?
Re: Data not reaching Wx nets
Posted: Fri May 02, 2025 3:46 pm
by Laxet
Attached is the System - Info tab
In case it matters, It is connected via cable to an Eero 6 port.
Re: Data not reaching Wx nets
Posted: Fri May 02, 2025 5:33 pm
by admin
Sorry, as internal storage is no longer shown as available the Internal USB hub chip has failed. It needs to be replaced.
I would repair for free, but sending from US to Germany and back will be the issue. Do you have some electronics guy around locally who can replace a SMB IC? Item to be replaced is a FE1.1s which is a $1 piece:
https://de.aliexpress.com/item/10050084 ... ry_from%3A
Re: Data not reaching Wx nets
Posted: Fri May 02, 2025 6:46 pm
by Laxet
It looks like I may be able to replace it myself. Is there a board layout drawing or photo available? BTW, the link you sent didn't work, but I was able to find them here with a quick search.
Worst case, I can finally upgrade to the Pro 2, which I've been trying to talk the wife into for some time.
Thank you for your help.
Re: Data not reaching Wx nets
Posted: Sat May 03, 2025 1:05 am
by admin
Here is shown how to open and close it:
https://www.youtube.com/watch?v=Wn0_tM_jjZI&t=6s
You have to unsolder the OLED (which you can also replace once being there) and then you have to desolder the FE1.1s and replace with new one. When you have a rework soldering station with a hot air tube it is not too complicated.
Link to FE1.1s:
- fe.png (151.73 KiB) Viewed 1553 times
Link to OLED:
- oled.png (469.05 KiB) Viewed 1553 times