Page 1 of 1
Meteobridge does not sense Meteostick. **solved**
Posted: Wed Jul 30, 2025 2:36 pm
by josecmorales
Hello.
I use a TL-WR902ACV3 with Meteostick RF direct to the ISS, but it is unstable despite being close to the ISS, But the strange thing is that the MB does not sense the meteostick either.
Re: Meteobridge does not sense Meteostick
Posted: Fri Aug 01, 2025 4:07 pm
by josecmorales
May be the power is not enough to feed the meteostick?
Re: Meteobridge does not sense Meteostick
Posted: Wed Aug 06, 2025 4:02 pm
by admin
Which RF threshold did you define on "Station" tab?
Re: Meteobridge does not sense Meteostick
Posted: Wed Aug 06, 2025 4:16 pm
by josecmorales
Those are my setup, the MS works fine for a few hours, later stops sense the ISS and the meteostick.
Re: Meteobridge does not sense Meteostick
Posted: Wed Aug 06, 2025 4:22 pm
by admin
You are picking up an enormous level of RF noise (reception rate - shown beside the indoor data - is just 0.5%!!). Please set RF threshold to -80db and/or look for a better, less RF noise exposed location.
Re: Meteobridge does not sense Meteostick
Posted: Wed Aug 06, 2025 10:21 pm
by josecmorales
admin wrote: Wed Aug 06, 2025 4:22 pm
You are picking up an enormous level of RF noise (reception rate - shown beside the indoor data - is just 0.5%!!). Please set RF threshold to -80db and/or look for a better, less RF noise exposed location.
Changed but still the same, worked for almost 4 hours.
Re: Meteobridge does not sense Meteostick
Posted: Mon Aug 11, 2025 5:40 pm
by josecmorales
I just add an extension of USB cable and done! works fine.
Thanks.