TP-Link Meteobridge won't load application stack.
Posted: Wed Jul 08, 2026 6:29 pm
It went down after a power outage on July 5 and hasn't come back since.
It is on my network and getting an IP address. When I connect to it I get the usual landing/loading page and no web UI:
"Meteobridge Landing Page (FW 1.4)
You got here, because Meteobridge application stack you wanted to access could not be loaded from the Internet. Most common reason for that is a bad network configuration of the Meteobridge device, that keeps the unit in endless fast blinking LED mode. From here you can do one of the following:
"
The network must be fine because it is connected to the network and all of the network information on that screen looks 100% correct.
Usually, a press of the reset button would solve this, but it doesn't seem to be coming back this time.
Any ideas?
It is on my network and getting an IP address. When I connect to it I get the usual landing/loading page and no web UI:
"Meteobridge Landing Page (FW 1.4)
You got here, because Meteobridge application stack you wanted to access could not be loaded from the Internet. Most common reason for that is a bad network configuration of the Meteobridge device, that keeps the unit in endless fast blinking LED mode. From here you can do one of the following:
"
The network must be fine because it is connected to the network and all of the network information on that screen looks 100% correct.
Usually, a press of the reset button would solve this, but it doesn't seem to be coming back this time.
Any ideas?