[resolved]New sensors working but not on Sensors page after

[skyewright]

I just added 3 'data' sensors to the Sensors page.

data1 (Uptime) added to the "System" weather station

data18 & data19 added to my 1-wire plug-in weather station.

After "Save & Restart Data Logging" and then reboot[1], data from the new sensors is being logged in the raw data but they do not appear on the Sensors page (either as assigned or unassigned) and they are not available to graph definitions.

Any ideas?

[1] reboot was needed in order to successfully restart logging.

[skyewright]

Any ideas?

Clicking "Save & Restart Data Logging" to "save" the Sensors without the (invisible) new ones did the trick.

After that the "new" sensors were there again, but unassigned, which allowed me to assign them afresh.

All up and running now. :cheer: