Sensor calibration

[stein42]

Hello everybody

I read somewhere that it's possible to calibrate each weather station sensors. But I can't find where it was.

Here is an exemple :
Weather station and my three sensors are located in the same place and I have following temperature values : 21.5 22 2.3 21.9

Is it possible to correct values given by sensors into Meteohub ?

Thanks by advance

Regards

[shinebar]

Just open the menu "Settings" or in German "Einstellungen". At the bottom of this page your'e able to calbrate each of your sensors.

[stein42]

Thanks a lot it works well now !!