meteohub.de

Hello,

I do not have a blank field for sensor definition on sensor page.
Mister Pasternak logs in my Meteohub 3D3 ALX3W and find that: the data coming in via USB show lots of read/init errors.

The weather station WMR88 is defined on meteohub log page, but I have no white stroke on sensor page under the weather station notifacation.
So I can not give the sensors an ID.
The Oregon software and a virtual Weather station does see the sensors.

The WMR 88 was disconnected for a few days because of transport, after good working.

Please help.

Hi,

Can you post some screenshots as the description of your problem is not very clear to me.

Thanks,

Ysbrand

Thank Ysbrand,

Screenshots ara posted.

I hope that they clear the problem.

krgds

Hi,

It appears to me that you are still having communications problems between MH and the weather station. Sometimes the dmesg log will reveal additional information.

Other than that the 1st thing I would recommend is to update Meteohub to the current version. Beyond that you can try a different USB cable, reboot/reset your WMR.

Ysbrand

Hello,

I have the Meteohub updated to: 4.9i, connected a new USB cable, reboot Meteohub and WMR88.
Still have no white stroke on the sensor page, in the weather station field, to give the sensors a ID.
I Go away for an few days and let everything on, maybe after that few days there is a white stroke.

Is it possible to make a factory reset for the Meteohub, so I can get clear software on Meteohub?

krgs

there is no factory reset button, but you can setup the CF card from scratch with the USB installer stick. Please read here: http://wiki.meteohub.de/Setup_ALIX.1D
Activation code will remain the same (please copy it into a save location as you will need to enter it again).

Hello Admin,

Do you have any other suggestions?

Please I still have no blank stroke for sensor ID.

krgs

Hi Wilmastop

Did you find a solution ? I have the same problem. I managed to add the WMR88 from the "Weather Station" menu. But after that I can't add the sensors, there nothing in the trigger listbox.
With the the Oregon software all is working correctly

I had the same problem but just left everything running for about 4 hours and the sensors started to appear. Seem that they need a bit of time to be recognised.