meteohub.de

I used to have a 64GB unsupported SD card but moved to a 16GB SLC card now. I used the manual steps you listed and my Meteobridge is up and running again.

Thank you for your help!

I've been running Meteobridge on a Raspberry Pi 4 Model B for a while. I was not able to find a supported SLC card initially and started with using an unsupported SD card.

I have now purchased a supported Industrial SLC SD card and would like to transfer the data from my old SD card to this new ...

I've been successfully using a D-Link DIR-505L for Meteobridge for a few years, but recently changed to a Raspberry Pi.
Now I would like to restore the D-Link factory firmware on the DIR-505L before selling/giving it up.

I've already downloaded the latest (very old) firmware from the D-Link site ...

OK, thanks for your response.

By the way, I just checked the latest version, and the issue with mapping a sensor as "No Mapping" is still there. It seems to take effect until you leave the tab. Once you leave the tab (i.e. after the setting the sensor to "No Mapping" let it accept the mapping and then go to any other tab) and ...

Then I must be misunderstanding something... Can you help me understand it, please?

Weatherflow Tempest station does not have any indoor sensors. Meteobridge is mapping thb0!0dew, thb0!0hum and thb0!0temp as indoor devices/sensors. Are these spurious/extra sensors that Tempest is reporting or are ...

I am using a WeatherFlow Tempest station and Meteobridge is mapping some of the sensors as "indoor" data. Tempest doesn't have any indoor temp/humidity/pressure sensors.

Meteo_mapping.PNG

I've tried to correct this using the Mapping screen of Meteobridge by selecting and setting the affected ...

I'm hoping one of you folks will be able to help me set up and configure my new Tempest weather station...

I've set it up and it is working OK. The only issue I have now is that Meteobridge is mapping some of the sensors as "indoor" data. I don't believe Tempest has any indoor temp/humidity ...

Hi Brian,

I noticed that Meteobridge has incorporated direct support for Luftdaten sensors after the last reboot/update. As you see in the attached images, the Luftdaten can be added as a station and its data shows in the "raw Data" and "Min/Max Data" screens of Meteobridge and hopefully it ...